After transfering the VW Bug’s passenger side motor mount profile to the steel angle, I can now cut them out with the plasma cutter. These two pieces will be used to create the Toyota MR2’s passenger side motor mount. Continuing work on the custom VW Bug.
With the VW bug 3SGTE passenger side motor mount template created, I must transfer the profile to the steel angle iron. I will cut these brackets from 2″x2″x3/16″ angle iron.
With the VW’s driver side motor mount in place I must create the passenger side motor mount. I have cut out a piece of the foam board to match the desired profile of the 3SGTE’s passenger side motor mount.
After carefully aligning the 3SGTE’s driver side motor mount, I can now tack weld it on to the VW Bug’s frame and remove the shop crane. I am planning the same technique for the passenger side motor mount.
Now that I have cut and drilled out the 3SGTE’s drivers side motor mount, I can now position it for welding to the VW Bug’s frame.
I have added some photos of the creation and positioning of the 3SGTE’s rear driver side motor mount. Check out the pics on the MR2 VW Bug Turbo Photos page.
I transferred the profile of the 3SGTE motor mount template to my steel tube. I am now cutting out the bracket with my plasma cutter.
With the VW rear frame plates in place, I can now create the 3SGTE motor mounts. I have created the foam template for the driver side motor mount and will transfer this profile to the steel pipe I plan to use.
With the Toyota MR2 rear cross-member bolted to the VW Bug frame, I need to do some fine tuning on the entire rear end engine cradle. I will construct the 3SGTE motor mounts once everything is perfectly aligned.
Both of the VW fame plate saddle mounts have been finished. I have now bolted the frame plates to the MR2’s rear cross-member. Everything seems to fit nicely. I ca now develop the 3SGTE motor mounts.