I now have the MR2 3SGTE rear cross-member installed as well as tying in all the suspension components. The two lower control arms and the two rear control linkages attach to the cross-member. This is a tight fit under the VW Bug body.
In this video you have to look for the changes. The engine is tilted back at the correct angle for the Toyota MR2 3SGTE engine. I also have blocks supporting the engine from below (no weight on the chains of the shop crane). I still need to install the rear cross-member to get everything exactly where it needs to be in the VW Bug rear end.
The VW Bug rear end assembly continues with the addition of the Toyota MR2 3SGTE driver side rear drive axle and wheel. Some initial alignment has also been completed.
After installing the MR2 passenger drive axle, I can now bolt the wheel on. The wheel will sit in the wooden box for the VW bug rear end alignment.
After installing the MR2 transmission, I am now able to start the rear end assembly. As you can see I have installed the passenger side rear drive axle.
I am installing the Toyota MR2 Clutch Masters stage 1 HD clutch. It should be good for mild 350-400 HP driving.
The Toyota MR2 flywheel and crankshaft needed to be secured (keep from spinning) in order to torque down the crank bolts. I used a small piece of wood backed up with a bolt turned sideways against the tranny locating pin in the block.
I can now install the Toyota MR2 3SGTE flywheel. It had to be machined twice, once for the bolt holes and once for resurfacing.
The MR2 transmission is ready to bolt up to the 2.2 3sgte stroker motor. I am waiting on the flywheel to be returned. The motor is in position to be incorporated into the VW Bug.
I have cleaned and painted the Toyota MR2 transmission. Ready for rear end drivetrain mockup on the VW Bug.