With the VW’s driver side motor mount in place I must create the passenger side motor mount. I have cut out a piece of the foam board to match the desired profile of the 3SGTE’s passenger side motor mount.

After carefully aligning the 3SGTE’s driver side motor mount, I can now tack weld it on to the VW Bug’s frame and remove the shop crane. I am planning the same technique for the passenger side motor mount.

I have added some photos of the creation and positioning of the 3SGTE’s rear driver side motor mount. Check out the pics on the MR2 VW Bug Turbo Photos page.

I transferred the profile of the 3SGTE motor mount template to my steel tube. I am now cutting out the bracket with my plasma cutter.

With the VW rear frame plates in place, I can now create the 3SGTE motor mounts. I have created the foam template for the driver side motor mount and will transfer this profile to the steel pipe I plan to use.

Both of the VW fame plate saddle mounts have been finished. I have now bolted the frame plates to the MR2’s rear cross-member. Everything seems to fit nicely. I ca now develop the 3SGTE motor mounts.

I have now finished drilling out both the driver and passenger side VW Bug plate frame holes. These four holes will be used to mount the plate frames to the Toyota MR2 crossmember. I still need to remove the steel above each bolt hole (where the nuts sit) in order to refit the frame plates. There are pictures of the steel removal on the pictures page at the top.